How post ID ads work
Every ad you build in Ads Manager quietly creates a Page post behind it, whether or not that post ever appears on your timeline, and each one gets its own identifier. Duplicate the ad into a second ad set and you get a second post with a second identifier. The two look identical to a viewer, but as far as the platform is concerned they are separate objects, so reactions and comments land on whichever copy that person happened to see.
The technique is to stop that split. You build the ad once, find the identifier of the post it created, then in every other ad set choose the existing-post option and paste that identifier in instead of uploading the creative again. All the ads now serve the same object, and every reaction, comment and share from every audience gathers on one thread.
Why post ID ads matter
Engagement is visible in the ad unit itself, and it is one of the few trust signals a stranger can read before clicking. Scattered across copies it looks like nothing; pooled onto a single post it reads as a busy, credible conversation. That is the whole argument, and it is the same reasoning behind advertising from an existing post in the first place.
There is a practical benefit too. One thread is one place to moderate. If you run several audiences, or the same campaign across two countries, you answer each question once rather than hunting for the same question under half a dozen near-identical ads.
Where post ID ads go wrong
The largest mistake is treating pooled engagement as the goal in itself. Reactions do not pay for anything, and a post with a crowded comment thread that nobody buys from is still a losing ad. Judge these ads on cost per result exactly as you would any other.
Bad comments pool as well as good ones, and now every audience sees them. Complaints, spam and competitor sniping all sit under the same post, so the moderation duty is heavier rather than lighter. There are structural limits too: the post belongs to one Page, so a campaign spanning several Pages cannot share it, and formats that assemble their own creative combinations may not accept an existing post at all. Finally, because every ad set serves the identical post, you cannot vary the copy by audience — if the message needs to change for a different country or language, this is the wrong technique.
How to act on it
Publish or build the creative once, let it collect its identifier, and then reuse that identifier everywhere the same message applies. Keep a note of which identifier belongs to which campaign, because the number itself tells you nothing later. Retire the post when the offer changes rather than editing it, and start the next one deliberately.
Where audiences genuinely need different wording, split them and accept that each starts cold — pooled proof is not worth a message that fits nobody. Ongoing Meta ads management is largely this kind of decision, repeated.
